SATA native IDE 40-Pin adapter for most enclosures.
DE-SATA04 is a Parallel ATA to Serial ATA Host mode Bridge Board featuring Jmicron JM20330 Serial ATA bridge Controller.

IDE-SATA04 is ideally suited for tailgate interface applications for removable-media drives CD-ROM, CD-R, CD-RW, DVD-ROM, DVD-RAM, tape drive, and hard disk drive.

Both ATA and ATAPI devices are supported using the same firmware. It allows SATA drives (Master or Slave) to be connected to ATA host controller. IDE-SATA04 provides the perfect solution for legacy ATA host controller to attach new SATA devices.

• Compliant with Serial ATA 1.0
• 48-bit sector addressing Serial ATA Connector:
• Signal + Power Female Type Connector Parallel ATA:
• Ultra ATA/133 Parallel Interface - 48-bit sector addressing - Jumper for selecting Mater and Slave Parallel ATA Connector:
• Male IDC 2X20 pin Connector Transfer Rate:
• Supports PIO and DMA modes - Supports bus master DMA at 1.5Gbps burst rate DC Power Connector:
• Mini 4-pin floppy type power connector Physical Dimensions: - 3.97" x 1.00" (10.09cm x 2.54cm)
• Direct Connect Vertical type

Windows 98
Windows NT 4.0
Windows 2000
Windows Me
Windows XP
Linux